AudioCodes MP-204B User Manual download pdf (Page 6)

11. Go to Advanced Configuration -> Media Settings -> Fax/Modem/CID Settings and ensure that:

Fax Transport Mode is T.38 Relay.

V.21 Modem Transport Type is set to Disable.

See Figure 5 below.

Figure 5

Dial Plan

Routing or dial plan entries must be configured to route calls in from the PSTN to the UC server and out

from the UC server to the PSTN.

Incoming

There must also be an answering point defined on the UC server for incoming PSTN calls. A standard

configuration has a UC server trunk identity of 10000.

Go to Protocol Management -> Endpoint Settings -> Automatic Dialing and:

1. Enable each of the trunks that are operational.

2. In Destination Phone Number add an entry of 10000 for each one.

1 2 3 4 5 6 7 8 9 10 11

No comments

AudioCodes MP-204B User Manual Page 6